HOW TO FIX MACARD WIFI EXTENDER CONNECTION DROPS

How to Fix Macard WiFi Extender Connection Drops

How to Fix Macard WiFi Extender Connection Drops

Blog Article

WiFi extenders like the Macard are designed to boost the signal coverage of your main router. However, if your extender keeps dropping the connection, there are several steps you can take to resolve the issue. Assuming your Macard WiFi extender is already set up, the following troubleshooting tips are meant to address problems that occur after installation.

1. Check the Power Supply to Your Extender
Unstable power is one of the most common reasons for WiFi extender disconnections. Here’s how to make sure the Macard extender is receiving consistent power:


  • Confirm that the extender is plugged into a functioning electrical outlet.

  • If your location suffers from frequent power outages, consider using a UPS (Uninterruptible Power Supply) to prevent unexpected shutdowns.

  • If power isn’t the issue, move on to the next troubleshooting steps.


2. Troubleshooting the Extender’s Connection to the Router
Using an Ethernet Cable:
If the extender is wired to the router using an Ethernet cable, ensure the cable is in good condition—no frays or cuts.

Double-check that the cable is securely plugged into the correct ports on both the extender and router.

Using WPS (Wi-Fi Protected Setup):
If you're using WPS to connect the extender to the router, keep the two devices within 20 to 50 feet of each other.

  • Too much distance can weaken the signal and lead to repeated disconnections.


3. Position Your Extender for Optimal Performance
Placement is critical to your extender’s effectiveness. To improve its connection:

  • Place the extender halfway between your router and the area with poor signal (the dead zone).

  • Avoid placing the extender more than 40 feet from the router.

  • Keep the extender away from large electronics or metal objects that might interfere with the signal.


4. Fixing Disconnection Issues with Connected Devices
If the extender stays connected to the router but disconnects from your devices, try these tips:

Restart the Network:
Power cycle your entire network by unplugging the extender and router, then plugging them back in after a few seconds.

Update Devices:

  • If one device keeps losing connection, restart it and check for available software updates.

  • If multiple devices are affected, log in to the Macard extender's interface from your computer and check if the extender firmware needs an update.


5. Reset the Macard Extender as a Last Resort
If none of the above steps work, you may need to reset the extender to its default settings:

  • Disconnect any connected devices.

  • Locate the reset button on the side of the extender—it’s usually a small pinhole.

  • Use a paperclip or pin to press and hold the button for about 10 seconds, then release it.

  • Wait for the extender to reboot and go through the setup process again.


Conclusion
The issue of your Macard WiFi extender losing connection can stem from various sources, including unstable power, poor placement, outdated firmware, or a weak link to your router. By following the troubleshooting steps outlined above, you can restore a stable and reliable connection for all your wireless devices.

Report this page